Comparative evaluation of Surface Roughness and Microbial Adhesion of Alkasite resin based composite Versus bioactive Giomer after simulated toothbrushing: An In Vitro study.

Elsisy, Wessam Fathy; Temirek, Marwa Mohamed; Hamza, Heba Salaheldin; Omar, Rania Rashad

doi:10.21608/asdj.2024.311280.1443

Comparative evaluation of Surface Roughness and Microbial Adhesion of Alkasite resin based composite Versus bioactive Giomer after simulated toothbrushing: An In Vitro study.

Document Type : Original articles

Authors

¹ Conservative department, faculty of dentistry October 6 university, Giza Egypt

² Conservative Dentistry – Faculty of Dentistry- October 6 University 6th of October City, 12563, EG

³ Conservative Dentistry Department, Faculty of Dentistry, Cairo University, 11 EL-Saraya St. Manial, Cairo, 11553, Egypt

⁴ Conservative Dentistry Department, Faculty of Dentistry, October 6 University, Egypt. 6th of October City, 12563, EG

10.21608/asdj.2024.311280.1443

Abstract

Aim: The present study aimed to evaluate the surface roughness and microbial adhesion of Alkasite resin-based composite versus bioactive Giomer after simulated toothbrushing.
Material and Methods: A total of forty-eight disc shaped specimens of giomer and alkasite resin based composites were set using Teflon split mold (1.5 × 8.5 mm) (n=6), finished and polished then the top surface of the specimens was subjected to simulated toothbrushing immediately. The specimens were randomly allocated into two groups; twenty-four each from both materials, for surface roughness (Ra) and microbial adhesion assessment then each group was subdivided into two groups according to time of assessment. The surface roughness was tested immediately (T1) and after three months of storage in distilled water (T2) by profilometer in micrometres. Microbial adhesion was tested after 24hours (Ta) and 48hours (Tb) of incubation using colony forming units. Selected samples from each subgroup were examined to monitor the surface before and after storage time using Scanning Electron Microscopy (SEM). Data were analyzed and tabulated using two-way ANOVA. Bonferroni correction was used for adjusting P-values for multiple comparisons. Coefficient Correlation analysis was done using Spearman's rank-order correlation. The significance level was set at (p<0.05).
Results: Alkasite showed a statistically significant higher surface roughness and microbial adhesion than Giomer at different times (p = 0.001).
Conclusions: Giomer had better performance in surface roughness and bacterial adhesion than Alkasite. Bacterial adhesion is strongly dependent on the surface roughness of restorations.

Keywords